ARMY TM 5-5420-212-23
MARINE CORPS TM 08676A-23/2
Two longitudinal girders are used to position the rear roller beam 15 ft from the front roller beam and ensure that
both roller beams are parallel to each other. The girder also assists in the assembly/disassembly of the end of bridge.
The dowels at the end of the girder are inserted in the holes in both roller beams. When the roller beams are
finally positioned the longitudinal girders remain located in the front roller beam but are removed from the rear roller
beam and lowered to the ground ready to assist in assembly/disassembly of the end of bridge.
(1) DOWELS. Used to locate the longitudinal girder in the roller beams.
Hydraulic Jack 15T & 20T
The hydraulic jack 15T is used in the construction of all single story, and double story MGB's with and without link
reinforcement, in the adjustable supports to level the roller beam. It is also used in the landing roller pedestal Mk 1 for
single story MGB and double story MGB without link reinforcement.
The hydraulic jack 20T is used in the landing roller pedestal Mk 2 on double story MGB's with link reinforcement.
The jack is identified by its data plate, and silver grey paint.
(1) HANDLE. Used to operate jack to raise ram.