ARMY TM 5-5420-212-23
MARINE CORPS TM 08676A-23/2
a.
Removal
(1) Unscrew and remove hexagon screw (1) from lever (2) and clean off all traces of thread locking compound.
(2) Tap out both spring pins (3) securing lever to post tensioning assembly (4), then remove lever (2) from post (4).
(3) Remove two hexagon head screws (5) and washers (6) then remove lever rubber (7) from lever (2).
(4) Remove old jointing compound from lever (2) and lever rubber (7).
b.
Inspection
(1) Inspect lever (2) for damage/distortion, replace with new if necessary.
(2) Inspect rubber block (7) for cracking and wear, replace with new rubber if badly worn.
c.
Installation
(1) Smear jointing compound on plate of lever rubber (7).
(2) Position lever rubber (7) on lever (2), then secure with two hexagon head screws (5) and washers (6).
(3) Position lever (2) on post (4), then tap in spring pins (3).
(4) Check that lever pivots freely.
NOTE
Coat threads of hexagon screw (1) with thread locking compound.
(5) Position lever (2) on post (4) with hexagon screw (1).
(6) Adjust screw (1) until toe of lever (2) just touches pulley shaft (8).
(7) Pull back on bottom of lever to ensure it operates correctly and allows pulley to be removed.
NOTE
Pulley will have to be fitted to check the above operation.
2-109
