TM 5-5420-208-12&P
listed in column 2. (For detailed explanation of these functions, see paragraph B-2.)
d. Column 4, Maintenance Level. Column 4 specifies, by the listing of a work time figure in the
appropriate subcolumn(s), the lowest level of maintenance authorized to perform the function listed in Column
3. This figure represents the active time required to perform the maintenance function at the indicated level of
maintenance. If the number or complexity of the tasks with in the listed maintenance function vary at different
maintenance levels, appropriate work time figures will be shown for each level. The number of man-hours
specified by the work time figure represents the average time required to restore an item (assembly,
subassembly. component, module, end item or system) to a serviceable condition under typical field operating
conditions. This time includes preparation time, troubleshooting time an quality assurance/quality control time
in addition to the time required to perform the specific tasks identified for the maintenance functions authorized
in the allocation chart. The symbol designations for the various maintenance levels are as follows:
C
Operator or crew
O
Unit maintenance.
F
Direct support maintenance.
H
General support maintenance.
D
Depot maintenance.
e. Column 5, Tools and Equipment Not applicable.
f. Column 6, Remarks. Not applicable.
B-4. Column Entries Used in Tool and Test Equipment Requirements . This section not applicable to this
equipment.
B-5. Explanation of Columns in Section IV . This section not applicable to this equipment.
SECTION II. MAINTENANCE ALLOCATION CHART
for
Cargo Pallet, Ribbon Bridge Transporter
NSN 5420-01-006-7436
(1)
(2)
(3)
(4)
(5)
(6)
Group
Component/
Maintenance
Maintenance
Tools and
Remarks
Number
Assembly
Function
Equipment
C
O
F
H
D
01
Nesting Pin, Retainer
Inspect
0.1
and Plates
Replace
0.1
01
Lift Pin
Inspect
0.1
Replace
0.1
03
Axle and Roller
Inspect
0.1
Assembly
Service
0.1
Replace
0.1
04
Identification and
Inspect
0.1
Instruction Plates
Replace
0.1
* Subcolumns are as follows:
C - Operator/Crew;
O - Unit;
F - Direct Support;
H - General Support;
D - Depot
**Indicates WT/MH required
B-2
