ARMY TM 5-5420-212-23
MARINE CORPS TM 08676A-23/2
2-32 ANCHOR ASSEMBLY, BONDED BEARING
This task covers:
a.
Inspection
b.
Removal
c.
Installation
INITIAL SETUP:
Tools Required
Tool Kit, General Mechanic's, Automotive (GMTK) (1, Appendix B, Section III)
Fitting and extracting tool, (5, Appendix B, Section III)
Materials Required
Thread locking compound (4, Appendix C)
Equipment Conditions
Anchor assembly on raised, flat surface with fork end anchors in stowed position
a. Inspection
(1)
With the fork end anchors (1) in the stowed position to expose the bonded bearings, fit a bracing pin into
the bonded bearing.
(2)
Move the pin from side to side to check if rubber(2) is separating from inner sleeve (3) or outer sleeve (4).
(3)
Replace bonded bearing if there is any sign of tearing, or cracking of rubber (2).
2-90
