ARMY TM 5-5420-212-23
MARINE CORPS TM 08676A-23/2
b. Removal
NOTE
Bonded bearings must be replaced in pairs.
(1)
Using the fitting and extracting tool, remove both bonded bearings.
(2)
Discard both bonded bearings.
c. Installation
(1)
Inspect hole in anchor link and check for burrs around edge of hole.
(2)
Carefully remove any burrs with a file.
(3)
Clean inside of hole with a clean cloth.
(4)
Ensure outside surfaces of new bearings are clean, then coat with thread locking compound.
(5)
Fit new bearings using the fitting and extracting tool, as shown.
(6)
Check that outer cases of bearings do not protrude above either side of anchor link plate, by more than
0.0126 in (0.32 mm).
(7)
Check that fork end anchors swivel freely.
2-91
