ARMY TM 5-5420-212-23
MARINE CORPS TM 08676A-23/3
3-13. ROCKING ROLLER
This task covers:
a.
Removal
b.
Inspection
c.
Repair
d.
Installation
INITIAL SETUP:
Tools Required
Tool Kit, General Mechanic's, Automotive (GMTK), (1, Appendix B, Section III)
3/4 in drive impact wrench (15, Appendix B, Section III)
21/4 in deep well socket (16, Appendix B, Section III)
Caliper face wrench (9, Appendix B, Section III)
Slide hammer (10, Appendix B, Section III)
Box wrench combination (13, Appendix B, Section III)
Paint brushes
Shop Equipment, Common No. 1 (2, Appendix B, Section III)
Protective gloves
Materials Required
Jointing compound Celloseel (6, Appendix C)
Grease, (1, Appendix C)
Cleaning solvent (3, Appendix C)
Clean cloths
Crocus cloth (10, Appendix C)
Thread locking compound (4, Appendix C)
Adhesive Cement
- Bostik Primer 9252, (23, Appendix C)
- Bostik Adhesive 2402 (24, Appendix C)
- Bostikure D Curing Agent D10 (25, Appendix C)
Boiling water in container large enough to submerge roller
Equipment Conditions
Rocking roller assembly on raised, flat surface.
WARNING
Components suspended In boiling water can cause severe burns. Always use protective gloves.
NOTE
This overhaul procedure does not include replacement of damaged shaft. If a shaft is obviously
damaged, report the condition to Depot Maintenance.
3-60
